Preparation Before Installation; Prepare The Following (Not Supplied) - Olimpia splendid Ci2 Wall Manual De Instrucciones

1.1 - PREPARATION BEFORE INSTALLATION

Check that the following are present in the package:
No
1 Remote control
2 Round cross-tip screwdriver
3 Round cross-tip screwdriver
4 Installation and use manual
5 Expansion plugs
6 Plastic support
7 Switching cables
for the signal receiving board
8 Switching cables for signal via cable

1.2 - PREPARE THE FOLLOWING (NOT SUPPLIED)

No
1 Switching cables
for the signal receiving board
2 Electric box
3 Wiring tube
(insulating sleeve
and clamping screw)
NOTE FOR INSTALLATION OF THE REMOTE CONTROL:
1. This installation manual contains information regarding installation and use of the remote control.
Refer to the appliance installation manual for connection between the latter and the remote control.
2. The wiring circuit between the appliance and remote control is low voltage.
Do not connect them to a standard 220V/380V circuit or introduce the wiring into the duct with live
cables.
3. The shielded cable must be connected to earth. If this is not the case, it may not operate correctly.
4. Do not attempt to extend the shielded cable. If necessary, use an extension cable with relevant joint
connector.
5. When the connection has been made, do not use a tester to control the level of isolation on the signal
cable.
Name
Name Quantity
(inserted
into the wall)
Qty
1
3
(For wall mounting)
2
For mounting on the box
of the electric switches
1
3 For wall mounting
2 For mounting on the box
of the electric switches
1 For reception of the signal
shielded cables with 4 wires
1 (If necessary)
For connection of the main control panel and
the shielded cable with 4 wires
Features
(for reference
only)
1 RVVP-0.5mm
1 ----------
----------
Remarks
-------------
M4x20
M4x25
-------------
Remarks
x4 longer by
2
15 metres
----------
----------
EN - 7