Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Self-cleaning function
This function cleans the inside of the soleplate
activate the self-cleaning function approximately every two weeks.
1. Fill the water tank
water" and set the steam control dial
2. Plug in the steam iron and set the temperature control dial
about two minutes until the steam iron reaches the maximum temperature.
3. Set the temperature control dial to 0 and unplug the steam iron from the
power outlet.
4. Hold the steam iron horizontally over a sink, then push and hold down the
self-clean button
Storage
1. Make sure the steam iron has cooled off completely and the water tank
is empty.
2. Wind the power cord loosely around the steam iron, making sure the cord
does not touch the soleplate
3. Store the steam iron out of the reach of children in a dry, well-ventilated area.
4. If you do not use the steam iron for a prolonged period, store it in the
original packaging to protect it against dust.
Troubleshooting
Issue
The soleplate
does not heat
up although
the steam
iron is on.
The steam
iron does not
produce any
steam.
10
to the MAX mark as described in the chapter "Adding
12
until the water tank is empty.
13
Possible cause
Loose connection or not
connected to the power
outlet.
The temperature control
dial is set to 0.
Not enough water in the
water tank.
The steam control dial has
not been set to steam
production ( ).
The selected temperature
is lower than the required
setting for the steam
function.
13
. It is recommended to
2
to the position
.
Check the steam iron is
plugged into the power
outlet.
Select a suitable
temperature.
Fill the water tank.
Set the steam control
dial between minimum
and maximum steam
production.
Select the correct
temperature for steam
ironing (
(no steam).
11
to MAX. Wait
Suggested solution
up to MAX).
Storage
10
23
Capítulos
Tabla de contenido
