Scratch Installation On The Seabob; Dangers - AirScape MiniDive Pro Instrucciones De Empleo

WARNINGS
• This operation has to be done by a professional
• The outlet air flow rate of the compressor has to be slowed down comparing to the filling of a diving tank
called « usual » of several litters
• The filling must be done very slowly, from 0 to 200 bar (3000 PSI) in 2 mins 30 secs minimum
• Make a break during the filling in case of a too important heating
7.

Scratch installation on the Seabob

This part only concerns people who have ordered the MiniDive Carbon with a fastening system for the Seabob.
The picture below shows the location of the various scratches on the Seabob.
The positioning of these scratch is done in 3 steps:
1) The scratch A, length 7cm, male, is placed below the metallic part circled in green, like on the picture.
2) Scratches B1 and B2, length 10cm, female, are placed on both sides of scratch A, in front of the buttons, like on the
picture below.
3) The scratch C, length 7cm, female, is placed at the middle of the right hearing of the Seabob. It has to hide the high
quarter of the hearing, as it can be seen below.
C
B
8.

Dangers

• The non-respect of these elementary rules of scuba diving may engender risks of drowning or physical damages which
can cause death
• In case of shock, the equipment can be damaged without visual harms, in case of doubt, make your equipment
inspected by a specialist
• It is totally forbidden to change the layout or to modify the different pieces of the MiniDive Pro (Pro+, Carbon)
• Never integrate elements from the MiniDive Pro (Pro +, Carbon) on an other (diving) equipment or vice versa
• Never introduce water in the equipment
B1
A
8