Troubleshooting - ADVANSEA WIND S400 Manual De Instrucciones

4. Troubleshooting

This troubleshooting guide assumes that you have read and understood this manual.
It is possible in many cases to solve difficulties without the need for the after-sales
service. Please read this chapter carefully before contacting your AdvanSea retailer.
1. The unit will not power on:
2. Wind speed or direction reading wrong or incoherent:
3. SIMU flashing on the screen, with incoherent readings
displayed.
If the problems persist, we recommend you contact your retailer.
Fuse melted or circuit breaker triggered.
Voltage too low
Power cable disconnected or damaged.
Incorrect calibration of wind speed.
Incorrect calibration of wind alignment.
Masthead sensor cable disconnected or damaged.
Masthead dirty or damaged.
Electrical interference. Review the installation.
Unit in simulation mode (see 2.4.7).
Installation and Operation Manual S400 series
20