NOCO Genius GEM MINI Guia Del Usuario página 8

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Connecting To The Battery.
Before you connect to the battery(s), make sure that the AC power
plug is not connected to an electrical outlet. DO NOT CONNECT
THE BATTERY CHARGER AC POWER PLUG TO THE ELECTRICAL
OUTLET UNTIL ALL OTHER CONNECTIONS ARE MADE. Make sure
you have identified the correct polarity of the battery terminals on the
battery(s). The POSITIVE battery terminal is typically marked by these
letters or symbols (POS,P,+). The NEGATIVE battery terminal is typically
marked by these letters or symbols (NEG,N,-). If you are having difficulty
determining the polarity of the battery terminals, contact the battery
manufacturer before proceeding.
1.) Confirm that you have a 12V battery(s). This battery charger is for
12V LEAD-ACID BATTERIES ONLY.
2.) Connect the POSITIVE (Red) eyelet terminal connector to the
POSITIVE (POS,P,+) battery terminal.
3.) Connect the NEGATIVE (Black) eyelet terminal connector to the
NEGATIVE (NEG,N,-) battery terminal.
4.) Repeat steps 2 and 3 for each battery bank.
5.) When disconnecting the battery charger, disconnect in the reverse
sequence, removing the NEGATIVE first.
How To Start Charging.
1.) Confirm that you have connected the eyelet terminal connectors
properly.
2.) Connect the battery charger's AC power plug into a suitable
electrical outlet. DO NOT FACE THE BATTERY WHEN MAKING THIS
CONNECTION.
3.) Charge battery(s) until fully charged. A Green LED will illuminate solid
when the battery is fully charged.
4.) The battery charger can be left connected to the battery at all times
to provide maintenance charging. However, it is good practice to check
the battery periodically.
Charger Maintenance.
GEN Mini Series On-Board Battery Chargers do not require any
maintenance. Do not attempt to open or repair the battery charger
as it will invalidate the limited warranty. A damp cloth may be used to
clean dust, dirt, or other debris off of the battery charger. BEFORE
ATTEMPTING TO CLEAN THE BATTERY CHARGER, MAKE SURE YOU
REMOVE THE AC POWER PLUG FROM THE POWER SOURCE.
Tabla de contenido
loading

Tabla de contenido