Work Table Parallel To Cutterhead; Know The Transmitting Rollers Of Your Planer - Powermatic 209 Serie Manual De Instrucciones De Operación Y Partes

Make sure all knife insert
screws are tightened securely. Loose inserts
can be propelled at high speed from a
rotating cutterhead, causing injury.

Work Table Parallel to Cutterhead

The work table is set parallel to the cutterhead at
the factory and no further adjustment should be
necessary. If your machine is planing a taper,
first check to see if the knives are set properly in
the cutterhead. Then check to see if the work
table is set parallel to the cutterhead. Proceed
as follows:
1. Disconnect machine from power source.
2. Place the gauge block (Figure 21) on the
work table directly under the edge of a knife
or knife insert as shown. Make slight contact
with the knife edge by gently raising the
table.
3. Move the gauge block to the opposite end of
the work table. The distance from the work
table to the edge of the knife should be the
same on both ends of the knife.
If the work table is not parallel to the cutterhead,
perform the adjustment procedure as follows:
1. Disconnect machine from power source.
2. Remove bolts holding the planer to the
stand. Tilt planer on its side to expose
underside of base (Figure 22).
3. Remove bolt (A, Figure 22) and loosen bolt
(B-Figure 22) which will allow you to move
the idler sprocket assembly (C, Figure 22)
far enough to release tension on the chain.
4. Remove the chain from the particular
sprocket on the corner of the base that you
need to adjust.
5. Turn the sprocket by hand to bring that
corner into adjustment with the other three
corners. NOTE: Turning sprocket clockwise
will increase the distance between the
working table and
counterclockwise will decrease the distance.
This adjustment is very sensitive and it
should not be necessary to turn the sprocket
more than one or two teeth.
6. When adjustments are correct, replace
chain around corner sprocket, slide idler
sprocket (C-Figure 22) back to re-tension
chain, tighten bolt (B, Figure 22) and insert
and tighten bolt (A, Figure 22).
the head casting;
Figure 21
Figure 22
Know the Transmitting Rollers of
Your Planer
(Figure 23)
A. Anti-Kickback Fingers
B. Infeed Roller
C. Chipbreaker
D. Cutterhead
E. Pressure Bar
F. Outfeed Roller
Figure 23
15