The Upper Receiver; Magazine Release Mechanism - Tippmann X7 Phenom Manual Del Usuario

The Upper Receiver

To disassemble the Upper Receiver:
1. Remove five
Receiver Screws
and lift the
Left Receiver Half
of the
Hex Nuts
Note that the Magazine Release Mechanism parts (8, 9, and 10) stay with the left half
of the Upper Receiver. For Magazine Release Mechanism disassembly instructions
see below.
2. Remove
Barrel Adapter
3. Clean and inspect parts for damage. Replace any damaged part.
4. Clean the inside of each Upper Receiver half.
Reassembly:
1. Make sure all parts are cleaned.
2. Place the
Right Upper Receiver
3. Insert the
Ball Latch
Receiver half. Make sure the Barrel Adapter is rotated to its locked position so it
doesn't slide out.
4. Use your finger tips to guide the Left Receiver half straight down on to Right Receiver
half until both receiver halves come together. If they do not fit flush the first time,
check to make sure the parts have stayed in place, and repeat until both halves come
together.
5. Insert five
Screws
are in the recessed areas designed for them. Carefully tighten all 5 screws (be careful
to not overtighten and strip threaded parts).

Magazine Release Mechanism

1. With receiver halves apart, push the
degrees, then release it.
2. Remove the
Magazine Release button
3. Remove
Magazine Release Pin
4. Clean and inspect parts. Replace any damaged parts. Reassemble in the reverse
order.
(7) holding the two Upper Receiver halves together,
(2) off from the
(6), as they might come loose from the Right Receiver half.
(5), remove
half (1) on flat surface.
(3),
Barrel Adapter
(7) into holes they were removed from. Make sure the Hex Nuts (6)
Magazine Release Button
(8) from the Left Upper Receiver.
Right Receiver Half
(3), remove
Ball Latch
(5), and
O-ring
(9) and (10).
Spring
25
(1). Keep track
(4).
O-ring
(4) into the Right
(9) and turn it 90
E
N
G
L
I
S
H