Pre-Start Inspection Procedures - Mi-T-M Corporation CAW-2004-0ME1 Manual De Operador

INSTALLATION & PREPARATION

PRE-START INSPECTION PROCEDURES:

Before starting the unit, perform the following procedures:
1. Inspect electrical cord for cuts. If a cut is found, DO NOT TOUCH OR USE
ELECTRICAL CORD! Replace cord before starting the unit.
2. Check the oil level in the pump.
3. Inspect the inlet water strainer. Clean or replace if necessary. See "Water
Supply", #2, pg. 12.
4. Check all hose connections to ensure they are securely tightened. See
"Water Supply", #3, pg. 12.
5. Inspect for system water leaks and oil leaks. Be sure that all damaged
parts are replaced and that the mechanical problems are corrected prior to
operation of the unit. If service is needed, contact Customer Service.
6. Inspect high pressure hose for kinking, cuts or leaks. If a cut or leak is
found, DO NOT USE HOSE! Replace hose before starting unit. Be sure
that all damaged parts are replaced and that the mechanical problems are
corrected prior to operation of the unit. If you need service, contact Customer
Service.
THE FOLLOWING PAGES CONTAIN OPERATING AND MAINTENANCE
DO NOT ATTEMPT TO OPERATE THIS PRESSURE WASHER UNTIL YOU HAVE
READ AND UNDERSTOOD ALL SAFETY PRECAUTIONS AND INSTRUCTIONS
INCORRECT OPERATION OF THIS UNIT CAN CAUSE SERIOUS INJURY!!
DO NOT ALTER OR MODIFY THIS EQUIPMENT IN ANY MANNER!
14
END OF PREPARATION INSTRUCTIONS
WARNING
INSTRUCTIONS
LISTED IN THIS MANUAL.
MI-T-M Electric Operator's Manual