Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TRANSAXLE GEAR SHIFT LEVER NEU-
TRAL ADJUSTMENT
The transaxle should be in neutral when the
gear shift lever is in neutral (N) (lock gate)
position. The adjustment is preset at the
factory; however, if adjustment is needed,
proceed as follows:
1. Ensure transaxle is in neutral (N).
NOTE: When the tractor rear wheels move
free[y, the transaxle is in neutral.
2. Loosen adjustment bolt in front of the
right rear wheel.
3. Position the gear shift Iever inthe neutral
(N) position.
4+ Tighten adjustment bolt securely,
NOTE: If additional clearance is needed to
get to adjustment bolt, move mower deck
height to the lowest position.
GearshiftLever
Neutral
Lock
AdjustmentBolt
Gate
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have asquare key- Do not lose).
3, Repair tire and reassemble.
NOTE: On rearwheels only: align grooves in
rear wheel hub and axle. Insert square key.
4. Replace washers and snap retaining ring
securely in axle groove.
5, Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, purchase and
use tire sealantfrom Sears. Tire sealant also
preventstire dry rot and corrosion.
Washers
Retaining
Ring \\\
FRONT WHEEL TOE-IN/CAMBER
Your new tractor front wheel toe-in and
camber is set at the factory and is normal.
The front wheel toe-in and camber are not
adjustable.
If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO START ENGINE WITH A WEAK BAT-
TERY
_WARNING:
Lead-acid batteries gener-
ate explosive gases, Keep sparks, flame
and smoking materials away from batteries.
Always wear eye protection when around
batteries.
Ifyour battery istoo weak to start the engine,
it should be recharged, (See "BATTERY" in
the MAINTENANCE section of this manual).
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: Your tractor is equipped with
a 12voltsystem. The othervehicle must also
be a 12 volt system. Do not use your tractor
............ battery to start other vehicles. ................................
TO ATTACH JUMPER CABLES -
1. Connect one end ofthe RED cab[etothe
POSITIVE (+) terminal of each battery(A-
B), taking care notto short against tractor
chassis.
2, Connect one end of the BLACK cable
to the NEGATIVE (-) terminal (C) of fully
charged battery.
3+ Connect the other end of the BLACK
cable (D) to good chassis ground, away
from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER-
1, BLACK cable first from chassis and then
from the fully charged battery.
2, RED cable fast from both batteries.
Weak or Dead
FullyCharged
Battery
Baltery
Axle Cover
'_Square
Key (Rear
Wheel Only)
24
Tabla de contenido
