Fitting The Beam And Cutting Head - KEENCUT OVAL 6 Manual De Instrucciones

3.1
NOTE:
1. Attach the Beam to the hinge of the Main Base using the two M6 screws and
spring washers.
2. Ensure precise alignment of the Beam by positioning it carefully on the small
ledge of the hinge.
Tighten the two socket screws firmly using the 5mm hexagon wrench.
3. Fit the Cutting Head to the Beam by sliding it onto the bracket until the edge of
the aluminium block aligns with the centre of the 'Lazy oval scale' as shown.
Tighten the thumbscrew.
4. Fit the Blade Holder to the shaft on the Cutting Head and fasten it by tightening
the black plastic thumbscrew.
The machine is now set to cut ovals 10cm and larger. For smaller ovals see
'4.6'.
Assembly

Fitting the Beam and Cutting Head

Do not carry the machine by the Turntable or Beam.
3.1