Installation And Wiring - Victron energy Skylla-i Manual De Usario

2. INSTALLATION AND WIRING

2.1. Installation
Find a dry and well-ventilated area to mount the Skylla charger and battery. Keep the cable length between the charger and the
battery less than 6 meters.
The charger may be wall or floor mounted. Vertical mounting improves the air circulation within the charger cabinet and will prolong
the lifetime of the battery charger.
Wall mounting
The unit can best be mounted to a wall using the supplied mounting plate. With this plate fixed to the wall, the charger can be hung
on this mounting plate. The charger can then be fixed by installing two screws at the lower backside of the charger. Now the charger
is fully secured.
Wiring
The inlets for the mains cable, the battery cables, the remote functions and the connection to attach the earth cable are located at
the bottom of the housing, see Figure 1 for the two output models and figure 3 for the three output models
Figure 1 Bottom view of cabinet showing cable
entries: two output models
1. Mains cable
2. Remote connections
3. Starter battery
4. Main battery
5. Grounding point
Figure 2 Bottom view of cabinet showing cable
entries: three output models
1. Mains cable
2. Remote connections
3. (not present)
4. Main batteries
5. Grounding point
4