Graco SLIMFIT Manual De Instructiones página 50

1" (2.5 cm)
50
Sliding Latch Plate and ALR
Retractor
A latchplate that slides freely on the belt
webbing and cannot, by itself, hold the belt
snug around a car seat.
Slowly pull the shoulder belt all the way
out. Route the vehicle seat belt through the
proper belt path and buckle it in. Then, as
you pull the vehicle seat belt tight, feed all the
slack back into the retractor.
Grab the sides of the seat at the belt path and
slide the seat side-to-side and front-to-back.
The seat should not move more than 1" (2.5
cm).
Sliding Latch Plate and ELR
Retractor
A latchplate that slides freely on the belt
webbing and cannot, by itself, hold the belt
snug around a car seat.
With this retractor, you will need to use the
locking clip to lock the vehicle seat belt.
Call us at 1-800-345-4109 to order a locking
clip.
Route the vehicle seat belt through the proper
belt path and buckle it in. Pull the vehicle seat
belt tight. While pushing down on seat, pinch
the two straps together behind the buckle
tongue. Unbuckle the belt without allowing it
to slip.
Attach locking clip to lap and shoulder belts
as shown.
Rebuckle belt. Check that lap belt does not
move by pulling hard. If belt loosens or
lengthens, repeat procedure.