Installing The Base; Before You Install; Adjusting The Recline Angle; Recline Angle Indicators - Britax B-SAFE Guia Del Usuario

Installing the Base

Before You Install

• Check that your vehicle seat belt is compatible with the infant car seat
by referring to your vehicle owner's manual and page 8 in this user
guide.
• For lap belt installation, check your vehicle owner's manual to
determine how to lock your vehicle belt system.
Adjusting the Recline
Angle
• To adjust the recline angle of
the base, hold in the recline
adjustment button on the recline
adjustment foot and move the foot
up or down.
• Correct recline angle is acheived
when the green marker on each
recline angle indicator is visible
between the two lines (see next
page).
• If there is a problem achieving
the proper recline angle after
following the previous steps:
* Try another approved seating
position in your vehicle
* Uninstall the base and lower
the recline angle adjustment
foot to the lowest position.
* Remove the base from the
vehicle.
* Place a rolled towel or pool
noodle in the vehicle seat bight.
* Place the base on the towel(s)
or pool noodle(s) to level the
base.
NOTE: If towel(s) or pool noodle(s) is
needed for recline angle, the recline
angle adjustment foot on the base
should remain in its lowest position.
12

Recline Angle Indicators

• Correct recline angle is acheived when the green marker on
each recline angle indicator is visible between the two lines.
• Vehicle must be parked on a level surface.

LATCH Connectors

• Push and hold the LATCH
connector release button
to remove the LATCH
connectors from the
storage slot in the base
or from the seat when
installed.
• To store the LATCH
connectors, push the lower
connector into the storage
slot in the base until they
click into place.
NOTE:
* LATCH connectors should
always be stored in the
base when not in use.
Installing the Base
13