Numeric.indicator.(Display); Led; Keys - Pixsys ATR 900 Manual Instalador

6.1 Numeric indicator (display)
1 1234
2 1234
6.2

Led

2
3
4
5
6.3

Keys

6
7
8
9
10
10 - ATR 900/901 User manual
Main display normally displays the actual kiln temperature. During
configuration or programming it will display setpoint value, number
of segments or other values (temperature, rate, dwell etc.).
Only ATR901:
Secondary display shows the number of segment in progress or the
number of segment which is being programmed.
Only ATR900:
Leds shows the segment number of the firing cycle. All leds are flashing
when a delayed start has been programmed. When the cycle foresees
more than 7 segments, the 7th led stays ON also for the additional
segments.
Led is ON when the operator is entering a temperature or if the fun-
ction "simple controller" is running.
Led is ON when the operator is entering a time value for each segment
of a program.
Led flashes when the control output is on during a firing cycle or when
the function "simple controller" is running.
Increases the displayed value:
• Parameter value during configuration
• Setpoint value if operating as "simple controller" (see 8.3)
• Time or temperature value if entering a firing cycle.
• Scroll through the parameters during configuration.
• Scroll through the segments within the selected program
Decreases the displayed value:
• Setpoint value if operating as "simple controller" (see 8.3)
• Time or temperature value if entering a firing cycle
• Parameter value during configuration
START / STOP key
• ESCAPE –key if programming parameters or cycles.
Scrolls through the cycles to select or start one
• Keep pressing it for about 5 sec. to enter configuration mode.