Turn On The Watch (First-Time Use Only); Batteries - Oregon Scientific RA202 Manual De Uso

TURN ON THE WATCH (FIRST-TIME USE ONLY)

Press any key for 2 seconds to activate the LCD
display.

BATTERIES

The watch uses a 1 x CR2032 lithium battery, which
has already been installed. See below for battery
warnings.
LOW BATTERY DESCRIPTION LOW BATTERY DESCRIPTION
ICON
The watch battery is low The watch battery is low
- - - - Appears when the battery is too low Appears when the battery is too low
to operate the sensor. "- -" is shown
instead of temperature, altitude,
barometer and compass values.
The bar and line charts will also be
NOTE Heavy use of the backlight, altitude alarm Heavy use of the backlight, altitude alarm
and sailing timer will reduce the battery service life
signifi cantly.
If you need to replace the battery, we highly recommend
that you contact the retailer or our customer service
department.
To replace the watch battery:
1. Locate the battery compartment on the back of the
watch.
2. Using a coin, as shown above, twist the compartment
lid counter-clockwise until it clicks out of place.
3. With your fi nger, remove the old battery.
4. Insert the new battery with the + side upwards.
5. Replace the battery compartment lid by twisting it
clockwise until it is fi rmly in place.
NOTE When you replace the batteries it is important When you replace the batteries it is important
to re-calibrate the magnetic sensor and altitude or sea
level. (See "Set the Altitude" or "Set the Altitude Alarm /
Sea Level / Weather Icon" section.)
5