Opex Falcon+ Manual Del Operador página 84

Table 4-1: Run Screen Buttons
Press Go to start the scanner.
The Page Type buttons indicate the page types assigned to the current
job. The use of the button varies depending on the job setup. See
"Assigning a Page Type" on page 79.
Rotate the image of the selected item. Use the three buttons to rotate
the image 90 degrees clockwise, 180 degrees clockwise, and front to
back. This button will only be available if it has been activated in the
System > Config > User Interface Settings parameters.
Press the Filter button to show only those items that require editing
using CertainScan Edit.
Press this button to filter blank images from the Thumbnail view.
Adjust the settings in the Capture Parameters window to enhance the
quality of the output images. See
"Adjusting the Image Quality" on
page 81.
Press a Rescan button to replace a previously scanned image with a
new one. This button will only be available if it has been activated in the
batch parameters. See
"Rescanning Items" on page 84.
Delete an item from the batch. This is only available when the scanner
is stopped. This button will only be available if it has been activated in
the batch parameters. See
"Deleting Items From The Batch" on page 90.
Void the selected item or set. This button will only be available if it has
been activated in the batch parameters.
Start / End a Set/Transaction. This button is only available if it has been
activated in the batch parameters.
Start / End a Group. This button is only available if it has been activated
in the batch parameters.
Start a New Batch. This button will only be available if it has been
activated in the batch parameters.
Press the Action button to access the Rescan, New Batch, and Void
buttons. The Action button only appears if two or more of these buttons
(Rescan, New Batch, Void) are enabled.
42 Operation
Falcon+ Operator Manual
OPEX Corporation