Gima SIRIO Manual De Uso Y Mantenimiento página 6

ENGLISH 6
referred to as the "systolic or maximum pressure".
Systole = maximum pressure level when the heart contracts and blood is pushed into the
blood vessels.
As you proceed with decompression, the pulsations gradually decrease until they suddenly
disappear or become so low as to be imperceptible.
The pressure indicated by the gauge needle at the moment the pulsations disappear is referred
to as the "diastolic or minimum pressure".
Diastole: minimum blood pressure level when the heart muscle is expanding and refilling with
blood.
4) Now completely open the release valve until air begins to come out of the armband. Blood
pressure measurement is now completed.
MAINTENANCE
1. Gauge and bulb
Cleaning: The gauge and bulb can be wiped with a damp cloth. Sterilization is not necessary,
as the parts do not come into direct contact with the patient's body.
2. Armbands
Cleaning: After removing the plenum chamber, the liners can be wiped with a damp cloth, or
you can wash them with soap and cold water. If you use this second method, rinse the armbands
with clean water and leave them to air dry. Nylon armbands must not be ironed.
The plenum chamber and tubes can be wiped with a damp cotton cloth.
GIMA WARRANTY CONDITIONS
Congratulations for purchasing a GIMA product.
This product meets high qualitative standards both as regards the material and the production.
The warranty is valid for 12 months from the date of supply of GIMA.
During the period of validity of the warranty, GIMA will repair and/or replace free of charge all the
defected parts due to production reasons. Labor costs and personnel traveling expenses and
packaging not included.
All components subject to wear are not included in the warranty.
The repair or replacement performed during the warranty period shall not extend the warranty.
The warranty is void in the following cases: repairs performed by unauthorized personnel or
with non-original spare parts, defects caused by negligence or incorrect use.
GIMA cannot be held responsible for malfunctioning on electronic devices or software due to
outside agents such as: voltage changes, electro-magnetic fields, radio interferences, etc.
The warranty is void if the above regulations are not observed and if the serial code (if available)
has been removed, cancelled or changed.
The defected products must be returned only to the dealer the product was purchased from.
Products sent to GIMA will be rejected.