To Begin Playback; Before Turning On The Power; Playback; Protection Circuit - TAD M4300 Manual Del Propietário

TO BEgIN PLAyBACk

Before turning on the power

Make sure that the input terminals and output terminals are securely connected.

Playback

1. Turn the volume knob of the Pre-Amplifier to its lowest setting.
2. Set the Pre-Amplifier's power switch to ON.
3. Set the unit's power switch to ON.
The power indicator will flash yellow for about eight seconds; when it lights steadily (yellow), the unit is ready for
operation.
Use the Pre-Amplifier's volume knob to adjust the volume.
4. To turn off the unit after use, first turn the volume knob of the Pre-Amplifier to its lowest setting, then turn off both the
Pre-Amplifier and the unit.

Protection circuit

The unit is provided with a built-in automatic protection circuit to prevent electrical damage to the amplifier and speakers.
When the protection circuit operates, the power indicator will flash, and no sound will be produced from the speakers. The
protection circuit may operate in the following circumstances:
When power is first turned ON
'
In order to silence potential noise during startup, the muting circuit operates for eight seconds; the indicator flashes
yellow during this time.
In event of malfunction
'
In the event of a short-circuit between speaker terminals, excessive load, or abnormal heat generation, the protection
circuit will operate and the indicator will flash red. The protection circuit is of the auto reset type. In the event the
protection circuit operates due to a malfunction, turn off the power, eliminate the source of the malfunction, and turn the
power on again.
15