TAD-M4300
Bi-AMP connection
Bi-AMPing is a connection method in which two sets of
amplifiers and speaker cables are used; one is connected
to the speaker's Low frequency and the other to the High
frequency inputs.
Do not turn on the power switches of this unit and other
'
connected components until all connections and settings
are completed.
When using this method, use only speakers that support
'
Bi-AMP connections, and be sure to set the Bi-AMP
selector switch to "Bi AMP".
Connect the unit's speaker output terminal pairs
'
outputting the same signal (SPEAKER L terminals 1 and
2, and SPEAKER R terminals 1 and 2) to the respective
speaker's High and Low terminals.
CAUTION
The Pre-Amplifier is connected to this unit's INPUT L
'
connector 1 and INPUT R connector 1. When using Bi-
AMP connections, signals from INPUT L connector 2 and
INPUT R connector 2 are not output to the speakers.
[Connection example using speaker systems
equipped with Bi-AMP connectors]
Rear panel of speaker
equipped with Bi-AMP
connectors
-
+
To speaker
terminal
High
Low
Speaker
+
-
SPEAKER R
1
1
Bi AMP
-
2
2
BALANCED
UNBALANCED
+
-
To balance
output terminal
Pre-Amplifier
12
Rear panel of speaker
equipped with Bi-AMP
connectors
-
+
To speaker
terminal
High
Low
-
+
Speaker
INPUT R
INPUT L
1
SPEAKER L
1
12V
BALANCED
TRIGGER
Bi AMP
IN
UNBALANCED
-
ON
AUTO
POWER
OFF
DOWN
4 CHANNEL
2
2
Bi AMP
UNBALANCED
BALANCED
-
+
AC IN
TAD-M4300
4 CHANNEL
Bi AMP
Note (TAD-M4300)
Since SPEAKER L/R terminals 1 and 2 produce the same
output signal, they can be connected to either of the
speaker's High or Low terminals.
CAUTION
(TAD-M4300)
When making Bi-AMP connections, be sure to remove
'
the speakers' High-Low short bar connectors to
avoid adverse influence on the amplifier. Consult the
operating instructions of your speaker system for further
information.