Assembly; Installing Drill Bit Into Keyless Chuck; Operating The Drill - Powerbuilt 641653 Manual De Instrucciones

because it does not have to be plugged into an electrical outlet. Always lock
the Trigger Switch and remove the battery pack before changing bits.
Before inserting a drill bit or other accessory, make sure the forward/reverse and
trigger lock lever is in the center "OFF" position to prevent accidental starts that may
result in injury.
Do not attempt to tighten drill bits (or any other accessory) by gripping the
front of the chuck and turning the tool on. This may cause personal injury and/or
damage to the chuck.
When removing the bit from the tool, avoid contact with skin and use proper
protective gloves when grasping the bit or accessory. Accessories may be hot
after prolonged use.
1. Hold the rear end of the chuck in one
hand and use the other hand to rotate the
front end in a counterclockwise direction
to open the jaws of the chuck.
2. Insert the shank of the bit (or other
accessory) fully into the keyless chuck,
taking care to keep the bit in the center of
the jaws of the chuck.
3. Turn the front end of the chuck clockwise
to hold the bit in place.
4. Tighten securely by turning the front end
of the chuck clockwise while holding the
rear end.
speed. The tool may fail under such conditions causing fire or personal injury.
Be aware that this tool is always in an operating condition

INSTALLING DRILL BIT INTO KEYLESS CHUCK

OPERATING THE DRILL

Never tape the trigger switch down to provide continuous high

ASSEMBLY

13
RELEASE
GRIP
HOLD
HERE
HOLD
HERE