Tabla de contenido
INSTALLATION WITH CABLE AND PLUG
The unit comes with power cord and plug protruding from a hole in the rear bottom and sliding along a guide
towards the bottom. The power outlet should therefore be recommended at a distance of 0.5 m from the bottom /
right part of equipment, at a height of 30 cm from the floor. (fig.3)
INSTALLATION UNDER TRACK
You can remove the plug and use the cable for wall installation without the warranty is void. (fig.3)
OPERATION
Once the power supply is installed and activated, the appliance is immediately ready for use.
Insert your hands into the appliance and move it from top to bottom to dry its entire surface. (fig.4)
The dryer comes into operation and stops automatically by inserting it thoroughly and moving your hands away.
The towels allow quick drying in 10-12 seconds. After approximately 30 seconds, the appliance stops automatically.
It is necessary to remove the hands for about 2 seconds and reinsert them to activate it again.
Air temperature: the air is delivered at full speed at a temperature of around 40 degrees and automatically adjusted
by an electrical resistance. An intelligent control system activates the resistance when the ambient temperature
is below 20 degrees centigrade to guarantee maximum energy savings. For the appliance manager it is possible
in any case in which the environmental conditions or use make it necessary, to constantly deactivate the heating
element, using the switch hidden behind the water tray, on the bottom of the appliance. (fig.5)
SAFETY
The appliance has an intelligent anti-vandal activation system that prevents continuous operation, caused for
example by partial coverage of the photocells. It will be sufficient to remove the cover that obstructs the photocells
so that the dryer resumes hisnormal function. The appliance is equipped with thermostats and thermo-fuses to
maximize safety in case of malfunction or excessive overheating
MAINTENANCE AND CLEANING
Warning: before carrying out any maintenance operation disconnect the appliance from the mains.
The appliance is equipped with 2 UV LEDs constantly operating inside the engine compartment. They preserve
the internal block from molds, bacteria and viruses and do not require any maintenance, being the LED light
much more durable than normal incandescent light bulbs (we consider 50,000 hours as the average duration
of the LEDs, time beyond which the radiation can start to break down up to 20-30% without ever stopping).
The bacterial charge is then knocked down when injecting air thanks to a double EPA11 filter positioned on
the air intake grilles, on the sides of the cover.
The cleaning methods for the machine and the filters are listed below.
Clean the towels using a soft cloth, moistened with water and detergent.
Do not clean this appliance with jets of water, water cleaners, water spray or aggressive detergents.
Water jets could reach the motor or the electronic parts and damage them irreparably.
Such damage is not covered by the manufacturer's warranty.
The jets of water also soak the EPA filters 11 positioned in the lower part of the cover and make the suction difficult,
causing the engine to suffer with possible damage not covered by warranty.
Periodically empty the tray, if possible every day, clean it under running water, removing all the residues and dirt
accumulated, as shown in the image. (fig.6)
If the HEPA filters are present, to ensure the durability and reliability of this dryer, periodically check (MAXIMUM
EVERY 2 MONTHS) that the suction filters are in good condition and if necessary clean with a jet of compressed
air that is not filter paper. Do not touch the filter paper because it can be damaged by hand.
The appliance works even without the filters installed
How to clean the filters:
- After removing water tank pull upward the cover to remove it. (fig. 7A)
- Remove filters and clean with soft compressed air. (fig. 7B)
NEVER LET THE FILTERS GET WET OR SPRAYED OR ANY WATER ON IT in any case.
9
Tabla de contenido
