Typical Installation - Powermate Vx 024-0294CT Manual De Instrucciones

Cuerpo air saw

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Key

Description

Air hose

In-line Filter

Tee Fitting

To begin using the tool:

As a standard practice, drain water from the

air compressor tank and air lines prior to use

each day (reference your compressor

operators manual for detailed instructions).

Install a 1/4" NPT male connector into the

air inlet port on the tool (see Figure 2). Note:

Use Teflon® Tape on all threaded

connections.

Turn on the air compressor and allow it to

build up pressure.

Adjust the air compressor's regulator or the

supply line regulator to 90 PSI.

Make sure the blade (L) and blade guard

(M) are secure before each use (reference

"Replacing blades").

Never use a cracked or dull blade. Never use the tool with the blade guard or cover

removed.

Connect the tool to the air hose quick coupler. NOTE: It is recommended that a whip hose with a swivel

(not included) be used to prevent twisting, kinking and excessive wear to the air hose (ref. item "F"

in figure 1 for recommended connections).

Hold the saw with the front of the blade guard on the cutting surface to minimize chatter and allow for

smoother cutting action.

RISK OF EYE INJURY. Always wear ANSI Z87.1 approved safety goggles when using

an air tool. Air powered equipment and power tools are capable of propelling materials such as metal

chips, sawdust, and other debris at high speed which could result in serious eye injury.

Push the safety lever (P) forward to release the throttle (Q). Press down on the throttle and move the blade

slowly along the work surface. Do not force the saw, let it do the work. Release the throttle to stop the tool.

Note: Avoid covering the exhause port vent holes (O) during operation.

When finished, turn off the air supply and hold the saw a safe distance from yourself and others. Squeeze

the throttle to bleed off the remaining air. Disconnect the air hose.

Replacing blades:

Disconnect the air tool from the air supply.

Remove the blade guard (M) by loosening the 2 set screws (U) on

both sides of the tool using the allen wrench provided. Pull the blade

guard out of the tool.

Pull the cover (N) open.

Loosen the 2 set screws (V) on the blade chuck (W) using the allen

wrench provided. Remove the blade.

Insert the new blade and tighten the 2 set screws (V). Note: The

teeth of the blade should be facing upward when the saw is upside

down.