Kingfisher NE10EPC Manual Del Usuario página 9

INSTALLATION
To hang the heater on the wall:
1. Choose a suitable installation location for the
heater. (Figure 1)
2. Disassemble the wall bracket by loosening the
screw (do not remove, only loosen) and slide the
metal plate out of the hole. Take out the bracket by
pulling down (Figure 2).
3. Verify that the bracket is perfectly horizontal with
a spirit level and mark the location of holes (4 holes
for NE10EPC/NE15EPC/NE20EPC, 3 holes for
NE5EPC, 2 holes for NE10PCS) on the wall. Insert
the pegs into the holes, then screw securely wall
mount bracket onto the wall. (Figure 3)
4. Place the heater against bracket (Figure 4):
A : Align the heater on the lower hooks that are
downwards.
B : Pull the heater upwards whilst retaining it in the
lower hooks.
C : Align the heater on the upper hooks that are
upwards.
D : Pull the heater down.
5. Slide the metal plate into the hole, and fasten the
screw to lock the wall mount bracket (Figure 5).
Before you start
EN 09