Idiomas disponibles
Idiomas disponibles
Serie 52
122
MODEL I
WARNING
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A
SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY
TRAINED STAFF.
INCORRECT HANDLING OF THE PARTS OR THE
LIGHT FIXTURE ITSELF MAY IMPAIR THE PROPER
PERFORMANCE OF THIS PRODUCT. IN THIS CASE,
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID: IF THE INSTALLATION IS NOT PERFORMED IN
ACCORDANCE WITH THE SPANISH LOW VOLTAGE
ELECTROTECHNICAL REGULATION 2002 (REBT 2002).
ATTENTION!!!
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE DEVICES.
1/2
abril 2020
FOR
ELECTROSTATIC
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
134
MODEL II
PROPERTIES:
• 230V, 50Hz
• E27 lamp holder.
• IP44.
• Stainless steel body.
• Polycarbonate diffuser.
• Suitable for mounting on normally flammable surfaces.
PRECAUTIONS:
• Keep the product away from children.
• This product is for outdoor use.
• Do not immerse this product in water or handle it with wet hands.
• If the device or polycarbonate diffuser is damaged or cracked, replace it
with a new one.
• This product must be installed by qualified personnel, in case of doubt
consult a specialized technician.
• Always turn off the power before handling the product.
ASSEMBLY INSTRUCTIONS:
1. Be sure to turn off the power before making connections and follow these
steps.
2. Route the wall or ceiling power cables into the socket ring.
3. Insert the installation tube into the power cables.
4. Connect the cables to the socket according to their colors: Brown (L), Blue
(N) and Green-Yellow
5. You must fully cover the cables in their proper places in an appropriate
manner.
6. Secure the lamp holder to the wall or ceiling with screws.
7. Install the bulb, it should not exceed the wattage specified on the label.
8. Secure the protective glass to the socket with screws.
SECURITY INSTRUCTIONS:
• Before starting the installation, turn off the power.
• Do not touch the bulb while it is operating, as it will become hot under
normal use.
• If you need to change the lamp, first turn off the power and reset it only
when you have finished installing the protective glass.
• The bulb must not exceed the specifications of the socket.
• If the protective glass breaks, replace it with a new one, do not use the
luminaire without protective glass.
• Be sure to connect the ground.
LAMP REPLACEMENT:
1. Turn off the power.
2. Remove the protective glass and access cover.
3. Carefully remove the bulb to be replaced when cold.
4. Replace the new bulb, if you do it with bare hands, clean it once inserted.
5. Put on the protective cover and glass.
6. Restore current.
122
MODEL III
.
