G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Declaration Of Conformity - SUHNER ABRASIVE LSB 70-TOP Documentación Técnica

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LSB
70-TOP.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with milling cutters and grinding
attachments.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 11/2019.
T. Fischer/Managing Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Si raccomanda aria compressa
oleosa(see also air quality under
section 2.3). Observe national reg-
ulations.
Maschine only to use together with the SUHNER
Airline-Filter LF 05. Capacity 5 micron. Connection G 1/4"
(order no. 05771001) or NPT 1/4" (no. 05771002 USA).
Operation tool without Airline-Filter cancels any warranty
claim.
2.2 t
AKing the mAchine into serVice
Before connecting the tool to the com-
pressed air supply set the pin to the «OFF»
position! The tool may be switched on only
when the attachment have been installed correctly.
16
s
otes on aFety
ommIssIonIng
2.2.1 t /t
urn on urn off
In the machine, push pin until it stops (in direction of ar-
row). The pin with the red dot protrudes. Pressing in the
opposite direction, the machine switches off.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Sound pressure level EN ISO 15744 74dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng
3.1 t
ools
Use only clean tools!
3.1.1 c /f
hAnging itting the tool
max. 6.3bar
220W
0.9m /min
3
0.25m /min
3
about 1-2 drops/min
70000min
-1
3.3m/s , K=2.0m/s
2 2
2/4/3
0.420kg
/ o
PeratIon