Dear buyer, thank you for purchasing our product.
PRIOR TO THE INSTALLATION AND FIRST USE OF HEAT PUMP WATER HEATER, PLEASE
READ THESE INSTRUCTIONS CAREFULLY.
This heat pump water heater has been manufactured in compliance with the relevant Standards, which allow the manufacturer the
use of the CE sign. The technical characteristics of the product are listed on the label attached to the protective cover.
The connection of the heat pump water heater to the plumbing and power networks must be carried out by qualified staff only. All
repairs and maintenance work in the interior of the storage tank, as well as limestone removal or testing or replacement of
the corrosion protection anode, may only be carried out by an approved maintenance service provider. Be especially careful
when following instructions for potential errors and safe use of the appliance.
Store this booklet for times of doubt upon the functioning or maintenance.
The installation manual is available on our webpage http://www.gorenje.com or the webpages per country in the service and support
section.
Authorised maintenance personnel are available for occasional maintenance. They will help you with their vast experience.
The design of the heat pump water heater and built-in shell and tube heat exchanger also allows using other heating sources, such as
the central heating tank, solar panels etc.
USE
This heat pump water heater is designed for production of sanitary water in households and at premises where daily consumption of
hot water (50 °C) does not exceed 400 l to 700 l. The set temperature should suffice actual needs. Recommended temperature
settings are between 45 and 55 °C. Higher temperatures are not recommended as they reduce the efficiency (COP) and
extend the time of heating or increase the number of operating hours. Because the heat pump water heater cools its
surroundings during operation, the usefulness of the appliance is doubled (heating water – cooling air). The operation of the heat
pump water heater is fully automatic.
The appliance must be connected to water supply mains and to the power supply grid. Leave enough room above the appliance for
easier control and appliance servicing (figures 2 and 3). The appliance may not be used for purposes other than those defined in
these Instructions. The appliance is not designed for use in rooms where corrosive or explosive substances are present.
The manufacturer shall not assume any liability for damages caused by incorrect installation or misuse that are not in compliance with
the Instructions for installation and use.
The instructions for use are a component and important part of this product and must be delivered to the customer. Read
the warnings carefully, as they contain important directions related to safety during operation, use and maintenance.
Keep these Instructions for later use.
The marking of the appliance is stated on the nameplate located on the bottom side of the unit, between both inlet pipes for sanitary
water.
Once the packaging is removed, check the contents. When in doubt, contact your dealer. Never let children play with the packaging
parts (clamping, plastic bags, expanded polystyrene, etc.) – potential risk. Make sure to remove and dispose of the packaging safely
and in an environmentally friendly way.
The appliance is not intended for use in closed space, containing corrosive and explosive materials.
STORAGE AND TRANSPORT
Store the appliance in an upright position, in a clean and dry place.
During transport, the appliance must be placed in the upright position and may only be inclined by up to 35° in all
directions in exceptional cases. Please make sure no damage of the casing and other vital parts of the appliance occurs
during transport.
14