NTP tab
Note
The recorder can synchronise the time with an
external server. Several server addresses are
available on the internet for this purpose.
1.
Tick the "Enable NTP" box and enter the interval
after which synchronisation should be repeated.
Enter the IP address of the NTP server and the NTP
port.
2.
Apply the data by clicking on Apply.
Email tab
In the event of an alarm, the device can send a message
by email. Enter the email configuration here.
Parameter
Setting
Enable Server
Tick the box when logged onto the
Authentication
internet provider's server
User Name
Email account with the provider
92
Password
Password used to protect the email
account
SMTP Server
SMTP server address of the
provider.
SMTP Port
Enter the SMTP port
Enable SSL
Tick the box to enable email
encryption
Sender
Name of the sender
Sender's
The email address linked to the
Address
email account
Select
Select three potential recipients for
Receivers
the email
Receiver
Enter the name of the recipient here
Receiver's
Enter the email address of the
Address
recipient
Enable Attached
Tick the box if camera recordings
Picture
should also be sent with the email as
photo files
Interval
Select a trigger time of between two
and five seconds. The pictures will
only be sent if motion is detected
during the time frame defined.
1.
Enter the parameters of the email notification.
2.
Then click on Test to send a test email.
3.
If you have entered everything correctly and have
received a confirmation email, click on Apply.
Note
The device will send an email to the specified
recipients.
If no email is received, check the settings and
correct them where necessary.
If necessary, check the junk mail settings for your
email client.
Note
You can obtain the access data and settings for
sending SMTP from your email provider. Some
email providers only provide SSL encryption for
sending emails. This recorder has been tested for
SSL compatibility with the following providers:
GMX, Web.de and Gmail.
Configuration