Hamilton Beach Professional K58 Manual De Instrucciones página 6

How to Use the Kettle
To change the Start Time if previously set, press and hold the
(PROGRAM) button for 2 seconds and the
light will flash. Change settings as previously described.
(PROGRAM) light will turn off after 3 seconds to confirm the Start
Time setting. Press the (PROGRAM) button to activate the Start
Time. The light will illuminate to confirm setting.
If no change is being made to the Start Time, press the
(PROGRAM) button to activate the Start Time. The light will
illuminate to confirm setting.
When the Start Time equals the actual time, the
light will shut off and the
illuminated. The Start Time, Preset Time, and Keep Warm time
(if it has been set) will be stored in the memory. When water
temperature reach desired preset temperature, the base will
chime two times and switch to Keep Warm. Once the Keep Warm
time has elapsed, the base will double-chime three times and
shut off.
If kettle floor discolors: It is normal for stainless steel heating
elements to discolor. This does not affect the performance of the
Kettle. Do not use abrasive scouring pads or cleaners since this
may damage the stainless steel surface.
If Kettle boils dry: The heating element is protected by two
automatic safety devices. If your Kettle is accidentally switched
on without being filled with water, or is allowed to boil dry, the
Kettle will automatically switch off and display and the lights will
start flashing and has the alarm sounds.
6
(PROGRAM)
(PROGRAM)
(ON/OFF/Standby) light will be
(cont.)
You should:
• Press (ON/OFF/Standby) to turn off, unplug, and wait about
20 minutes for the element to cool.
• Refill the kettle; then use as normal and check that the Kettle
functions correctly.
If Kettle does not work:
• Have you pressed the
position?
• If the Kettle heats but does not boil, it might need descaling
(see "Care and cleaning" section). • Has the Kettle been accidentally turned on without being filled
with water or allowed to boil dry? Press the
button to standby or unplug, wait 20 minutes, and try again.
• Is cord firmly plugged into the outlet and Kettle firmly seated in
the base?
Anti-Scale Mesh Filter: Scale is caused
by lime and calcium in hard water.
The Mesh Filter will prevent these
suspended particles from being poured
out of the Kettle. The filter should be
cleaned periodically to ensure optimum
performance.
To clean the filter, unplug Kettle and allow
to cool. Pull up on the filter tab to slide
filter out.
To replace filter, line up the filter with tab
towards the inside of the Kettle and slide into place until it snaps
into place.
(ON/OFF/Standby) button to ON
(ON/OFF/Standby)