Genesis GDP1012A Manual Del Operario página 12

WArNINg:
any drilling operation.
DRILLING TIPS
1. If a large hole is needed, it's a good idea to drill a smaller pilot hole before drilling the final one. Your hole will be
more accurately positioned, rounder, and the bits will last longer.
2. If the hole is deeper than it is wide, back off occasionally to clear the chips.
3. When drilling metal, lubricate the bit with oil to improve drilling action and increase bit life.
4. Smaller drill bits require greater speed than large drill bits. Softer materials require greater speed than harder
materials.
5. If drilling a through hole, make sure place a piece of backup material (wood, plywood, etc.) on the table underneath
the work piece to prevent splintering on the underside of the work piece.
MAINTENANCE
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. use clean cloths to remove dirt, dust, oil, grease, etc.
WArNINg:
products, penetrating oils, etc, come in contact with plastic parts. Chemicals can damage,
weaken or destroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass chips and groundings are highly abrasive to bearings,
brushes, commutators, etc. Consequently, we do not recommend using this tool for extended work on these types
of materials. However, if you do work with any of these materials, it is extremely important to clean the tool using
compressed air.
LUBRICATION
1. Lower spindle to maximum depth and oil moderately once every three months.
2. oil the column lightly every two months.
12
Make sure the chuck key is removed from the chuck before starting
Do not at any time let brake fluids, gasoline, petroleum-based
10" Drill Press
Operator's Manual GDP1012A