Descaling The Humidifier - Beper 70410 Manual De Instrucciones

Humidifiers with aroma oil box Use instructions

Descaling the humidifier

Disconnect the humidifier from the mains and set the on/off knob to 'off'.
Fill the water basin with 100ml of vinegar (4% acetic acid) per 200ml of water).
Leave the water and vinegar in the water basin for at least 4 hours (preferably overnight).
Empty the water basin and remove the scale with a soft cloth.
Put some white vinegar (4% acetic acid) on the steam generator and then wipe away the
vinegar with a moist cloth.
Rinse all parts with clean water.
TROUBLESHOOTING
If problems arise with the appliance and you are unable to solve them with
the information below, please contact Beper service centre.
MALFUNCTION
Power indicator can't work and
with no wind and mist
Power indicator illuminate, the
unit with wind but no mist
Smelly mist
Power indicator illuminate, the
unit with no wind and mist
Little mist comes out of the
nozzle
Abnormal noise
REASONS
Didn't connect the power
supply
Didn't turn on the humidifier
No water in the water tank
New humidifier
Dirty water or long-time to
store water in water tank
Too much water in the base
flume
Dirty Heater element
Caused by little water in water
tank.
Resonance from table-board
13
RESOLVE METHODS
Connect the humidifier from
the power supply
Switch on the unit
Fill water in water tank
Open water tank, put it in
shadow for 12 hours.
Clean the water tank, fill clean
water in.
Empty the flume, then close
the cap of water tank.
Clean the Heater element
Fill water in water tank.
Place on a stable level sur-
face.