Operation; First Network Configuration - Vortice Vort Delta T WIFI Manual De Instrucciones

ENGLISH

Operation

Max power: 5,38 mW
Operating frequency: 2412 ÷ 2472 Mhz
The user can interact with the system via a membrane keyboard. There is a buzzer (which can be disabled) for
the acoustic feedback from button presses.
The circuit board manages three types of operations:
- summer: air directed downwards
- winter Man: air directed upwards or downwards, as desired by the user; manual speed on and adjustment.
- winter Auto: air directed upwards or downwards, as desired by the user; speed on and adjustment managed
by the system based on the temperature values measured by the two probes.
In winter mode, it is possible to control automatic switching on or off of the heating system of the room selected
based on the temperature measured by the probe placed near the ground.
Meaning of icons/buttons on the control panel:
6
1
7

First network configuration

This operation must be performed by the installer.
When the device is switched on for the first time, the fans must be associated with the control unit. The system
has an identifier (SSID) and a default password.
A few minutes after system start-up, a network is created with SSID "NRDK_MESH" and the password:
12345678. The number of associated fans is shown on the display. The SSID and Password must be changed
at this point to avoid interference with any fans that do not have to be part of the network (if they are in an
adjacent building for example).
Note:
The initial factory default values for the SSID and password can in any case be restored if any of the following
configuration steps are not successful. To do so, press and hold the RESET button (hidden in the area at the
centre of the logo) for about 10 seconds until the LED begins flashing. After it has flashed a few times, the LED
will remain steady on for a few seconds and then switch off. The factory default values for the SSID and password
have now been reset. The same procedure must be followed on Wi-Fi cards for all fans connected in the network.
Changing SSID:
- Press the CONFIG button.
- Using the arrow buttons, view the item "CHANGE SSID". Press the OK button.
- Enter the name of the desired network (SSID) (UP/DOWN edits the character, RIGHT/LEFT moves by one
character). The number of characters allowed is between 8 and 12. Press the OK button.
5
3
2
1: CONFIG:
configurations
2: ESC: to exit without saving
3: OK: to save and exit
4: arrow buttons: right, left, up,
down
5: hidden button (centre of the
logo):
RESET
6: Two-line DISPLAY
7: LED (to confirm successful
"Reset")
4
to access
factory default values
19