Makita XSJ04 Manual De Instrucciones página 7

Cizalla inalámbrica para metal
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Removing and installing shear
blades
CAUTION:
Never remove the blades with bare
hands. Wear gloves.
The sharp edge of the blade may cause injury.
Removing cutting head
Use the hex wrench (5/32") to loosen the bolts which
secure the cutting head. Pull the cutting head straight
out by turning it left and right alternately.
1
2
3
► 1. Cutting head 2. Bolt 3. Hex wrench (5/32")
4. Loosen
Removing shear blades
NOTICE:
Hold the blades and the sleeve not to fall
from the cutting head.
NOTICE:
Be careful not to lose the sleeve.
Remove the bolts which hold the blades. Then the
blades can be removed easily.
3
2
4
5
► 1. Bolt 2. Side blade L 3. Center blade 4. Side blade
R 5. Sleeve
4
1
Installing shear blades
Insert the center blade, the side blade L, the side blade
R, and the sleeve into the cutting head.
Tighten the bolts. In this process, the bolt heads should
be protruding 2 - 3 mm from the cutting head surface.
If you tighten the bolts excessively, the cutting head
cannot be installed to the tool.
2
3
4
5
6
► 1. Cutting head 2. Side blade R 3. Center blade
4. Sleeve 5. Sleeve 6. Side blade L 7. Bolt
Installing cutting head
CAUTION:
Secure the cutting head firmly.
Otherwise the cutting head may rotate during opera-
tion and cause serious injury.
Insert the cutting head into the tool by turning it left and
right alternately. Then tighten the three bolts with the
hex wrench (5/32").
1
2
3
► 1. Cutting head 2. Bolt 3. Hex wrench (5/32")
4. Tighten
7 ENGLISH
1
7
4
Tabla de contenido
loading

Tabla de contenido