Hayward Pool RS3016VSTD Manual Del Usuario página 25

4.3 Setting the Skimmer function
See section 2.2 for an introduction to this function
• Press and hold DISP/FUNC for three seconds
All three LEDs will blink and the screen will display
"ConF"
• Press DISP/FUNC repeatedly until 'SFO.15' is
displayed on screen: this is the default Skimmer
time (in minutes)
• Press the up / down buttons to set the desired
value (0 to 30 minutes)
• Press DISP/FUNC: the screen will display "St 1hr"
- this is the default Skimmer cycle period
• Press the up / down buttons to set the Skimmer
cycle period to 1hr, 2hrs or 3hrs
• Press DISP/FUNC: the screen will display "S2800"
- this is the default speed of the Skimmer function
(rpm)
• Press the up/down buttons to display the desired
speed (600 to 3000 rpm)
• Press RUN/STOP to exit and save
The display will show the current speed or StoP
Note: To deactivate the Skimmer and set the time to
zero - display reads "SFoFF"
4.4 Restoring the settings
To restore the default settings and erase the Timer mode settings, do the following:
• Press and hold DISP/FUNC for three seconds
All three LEDs will blink and the screen will display
"ConF"
• Press DISP/FUNC repeatedly until the screen
displays the message 'Init'
• Press and hold the 'up' button for 3 seconds. The
screen will read "donE" once the reset is complete
Priming
Pr o___
Units s rpm
Default 240 3000
Mini 0 ( oFF) 600
Maxi 300 3000
Page 10 of 14
Reminder: default settings and their value ranges
Speed preset buttons
V1 V2
rpm rpm
1500 2400
600 600
3000 3000
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
>3s
x n
SF000
>3s
x n
>3s
Skimmer function
SF St
V3
rpm min h
3000 15 1
600 0 ( oFF ) 1 ...
3000 30 ... 3
Pump
ConF
SfO15
.
SFO20
.
St1h
St2h
S2800
S2680
/
1640 StoP
SFoFF
ConF
Init
dOnE
Timer function
S___ t0
rpm hh-min rpm
2800 06-00 2400
600 00-00 —
3000 24-00 —
StoP
t1 _ t5
hh-min rpm
0
oFF
00-00 0/ 600
24-00 3000