Changing Unit Measurements (Nm - Ft·lbf); Changing The Setting - PB Swiss Tools DigiTorque Instrucciones De Uso

SI
ft·lbf
Nm
Changing unit measurements (Nm – ft·lbf)
Once the device has been switched on, you can change the units
shown from metric (SI) to imperial (IMP) or vice versa by pressing the
display for 3 seconds.
2.58 1.90
3 sec.
3 Sek.
SI
Nm ft·lbf Nm ft·lbf
84
SI
Nm ft·lbf
IMP
min.

Changing the setting

The torque can be set as shown using the hexagon screwdriver sup-
plied. The range possibilities within it can be adjusted is printed on the
handle. The adjusted torque is shown immediately on the display at
the end of the handle.
The loosening torque is +100 % of the point set.
DigiTorque MultiTorque
min.
85