030955E_Anleitung
IGNITING AND ADJUSTING THE TORCH:
1. Connect the propane regulator to the gas bottle. Ensure that the connection is tight.
2. Then connect the recommended safety valve and only then connect the gas hose to the
safety valve and the propane handle. Again ensure the connections are tight.
3. Open the bottle cut-off valve first.
4. Then open the control valve on the tool (large control knob with +/- symbol). When using
small torches or freshly refilled gas bottles, allow the captured air to escape.
5. The built-in Piezo ignition device located above the burner is used to light a flame in the
burner. Press the red button to produce a spark and light a flame in the burner.
6. Increase gas flow with the integrated valve for full output. Ensure that the flame aspect
does not burn away from the nozzle edge as it will reduce output and temperature.
7. Retention flame persists until the gas throttle is actuated. By pressing the economizer lever
the torch gains full capacity as previously set.
8. For short work interruptions release economizer lever and the tool reduces the flow of gas
and the retention flame returns. It is essential that the torch holder is mounted in full
accordance with the assembly diagram.
9. Avoid torsional stress of the hose.
FEATURES
1
Torch
2
Pipe
3
5.0 m hose, R3/8'' threaded connection on both sides
4
Safety economizer valve – handle
5
Torch holder
6
Economizer lever
7
Control valve for regulating flame size
8
Safety valve (accessory)
9
Propane regulator (accessory)
(not included)
10 Piezo ignition button
WORK COMPLETION – SHUTTING OFF THE TORCH
Always close the torch valve. Reduce hose pressure to normal atmospheric pressure.
Before taking prolonged breaks or after work completion, close bottle valves and allow the
torch to burn off any excess gas. Then close gas regulator and allow hot parts to cool. Wait
until parts and components have fully cooled before disassembling and stowing gas
equipment.
06.10.2009
14:32 Uhr
8
Seite 8