FALMEC PRISMA Manual De Instrucciones página 22

Phase 3
- To prevent the hood from falling due to pressure below, fasten it to the wall with an expansion
plug and relative screw using the appropriate brackets "S" on the top of the hood (fig. 04).
- For the exhaust version, connect the output fitting of the fan (upper output or on rear) to the
external discharge with a suitable pipe (fig. 05).
- Set up the electric connection only after disconnecting the power supply of the
hood.
Phase 4 (optional) (fig. O5)
- Place extension (H) in the flue (G) and fasten this assembly to the body of the hood using the
screws (V2).
- Slide the extension (H) until it is positioned at the desired height.
- Once you have found the best position, lean the bracket (L) on the wall, verify the horizontal
alignment with a spirit level and mark 2 drilling points at the ends.
- Drill the holes, insert 2 expansion bolts of 4mm ø and fasten the bracket (L) with the relative
screws.
- Tighten the extension (H) to the bracket (L) using screws (M).
Phase 5
- Remount the hood, metal filters, and close the front glass panel.
- Power on the hood in accordance with current regulations (sec. D).
20