Worldcast Systems APT IP Codec Guía Rápida página 7

The Stream Configuration Window presents the standard view that is suitable for your first connection.
For configuring the "Advanced Options" refer to the manual section 3.4.10.
5.1. Apply a name to the Stream
5.2. Type can be Audio, AUX, GPIO and IP/Media Forward – select "Audio"
5.3. Enable either or both, transmit and/or receive field. For example, if you only wish the Codec
to transmit, then select "Transmit" but leave "Receive" unselected.
5.4. Choose the physical port you wish the IP traffic to use, either ETH0 or ETH1. These are
labeled on the back of the unit. ETH1 is the left port and ETH0 is the right port (viewed from
the rear)
5.5. Ignore "Channel Number" at this stage – this is for stream type "IP Forward" only.
5.6. Enter the destination IP address (if Transmit is enabled).
5.7. Enter the IP port – ensure the other side of the link has the same IP port configured.
Figure 0-4: Shows the position of ETH0 and ETH1 on the rear panel
6. Click on "ok" and your stream will then appear in the Streams Table. Add additional streams if
required
Figure 0-5: Shows the stream table with a Receive stream and a Transmit stream configured
7. Click on "Create" on the bottom of the toolbar to create the configuration.
8. To apply this configuration click on "Apply". This will immediately reconfigure the codec to these
settings.
English version
7