Bosch ALM 28 Instrucciones De Servicio página 13

EURO • Printed in England • BA F 016 L69 849 • ALM 28/30 • GB • OSW 10/01
ALM 28/30.book Seite 3 Freitag, 19. Oktober 2001 9:05 09
Assembly
A
Position the handle bottom 6 at the rear of the
motor cover.
Line up the holes and secure with the pivot
pins 9 provided.
Attach the handle top 3 with the bolts and wing
nuts 7 to the handle bottom 6.
Note: Ensure that the cable clips 8 supplied are
used to fix the cable to the handle.
Attach cable to cable restraint 5 ensuring that
B
sufficient cable slack is available.
Handle Adjustment
The handle can be set in three positions, as in
figure C:
Park position
I
II Handle location for mowing
III Handle location to enable mower to be hung on
walls.
To move the handle from location I or III to mowing
location II press together the tubes of the handle
bottom 6.
Adjusting the Cutting Height
Stop, release switch lever, wait until the
motor stops and remove the plug before
adjusting height. The blades continue to
rotate after the machine is switched off, a
rotating blade can cause injury.
For the first cutting of the season, a high cutting ad-
justment should be selected.
Your machine has two settings which give the fol-
lowing approximate height of cuts:
low = 20 mm
To change the height of cut, place the handle in the
park position and turn the mower on its side and hold
onto the fan 13 (figure D):
Turn the cutting disc 11 relative to the
fan 13 to unlock the cutting disc.
Push/pull the cutting disc 11 on low or
high cutting position.
Turn the cutting disc 11 relative to the
fan 13 to lock the cutting disc.
13 • F 016 L69 849 • TMS • 16.10.01
Starting and Stopping
To aid starting tilt mower to side.
Starting:
Stopping:
Release the switch lever 1.
Mowing
The motor cover is designed with a flexible mounting
and tilts to improve directional control.
Place the lawnmower on the edge of the lawn, as
close to the power point as possible. Work away
from the power point as in figure F. Then at right an-
gles.
Position the cable to opposite side (already cut) at
the end of each turn.
high = 30 mm
Maintenance
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as a loose,
dislodged or damaged blade, loose fixings, and
worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the mower should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorised customer service agent
for Bosch garden products.
English - 3
The blade continues to rotate for a few
seconds after the machine is switched off.
Allow the motor/blade to stop rotating be-
fore switching "on" again.
Do not rapidly switch off and on.
Press and hold the safety button 2.
(Figure E)
0
Squeeze the switch lever 1 towards the han-
dle.
2
1
I Release the safety button 2.
When mowing do not allow the motor to la-
bour particularly in heavy conditions.
When the motor labours the speed of the mo-
tor drops and you will hear a change in the
motor sound, when this occurs stop mowing,
release switch lever and raise the height of
cut. Failure to do so could damage the ma-
chine.
Stop and remove plug from the power sup-
ply.