Replacing The Lamp; Closing The Door - AEG SKS58800S1 Manual De Instrucciones

10 www.aeg.com
Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.

8.1 Replacing the lamp

CAUTION!
Disconnect the plug from the
mains socket.
2

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
Possible cause
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
The temperature regula-
tor is not set correctly.
1
1
Solution
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
1. At the same time, with the fingers ex-
pand up and down the transparent
cover and unhook it in the direction of
the arrows.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maxi-
mum power is shown on the light bulb
cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the
light comes on.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.