Kongskilde MULTICUTTER Instrucciones De Uso página 11

Application
The Multicutter is designed for cutting down trims of
plastic foils, aluminum foils, paper and cardboard.
The maximum thickness of plastic foils is 400 my, while
the maximum thickness of aluminum foils is 50 my.
The maximum weight for trims of paper and cardboard
is 500 g/m .
2
The Multicutter is designed for mounting in an
enclosed pipe system, that is, with a pipeline mounted
both at the inlet and outlet of the Multicutter.
Only use the Multicutter for cutting the materials it
is designed for due to risk of knives destruction or
damage.
Installation
Always check the direction of rotation of the motor
prior to mounting. Rotation of the Multicutter rotor
is anti-clockwise viewed from the motor side.
If the Multicutter rotor rotates in the opposite
direction, the knives cutting edge will be damage
immediately. Do not rotate the rotor manually in
the opposite direction as even a few rotations in
wrong direction may damage the knives.
Mounting the motor
Always check the direction of rotation of the motor
prior to mounting. Rotation of the Multicutter rotor
is anti-clockwise viewed from the motor side.
If the Multicutter rotor rotates in the opposite
direction, the knives cutting edge will be damage
immediately. Do not rotate the rotor manually in
the opposite direction as even a few rotations in
wrong direction may damage the knives.
The Kongskilde Multicutter may only be operated
and serviced by responsible and properly instructed
people.
The Multicutter is designed for mounting in an
enclosed pipe system, that is, with a pipeline mounted
both at the inlet and outlet of the Multicutter.
Make sure the material is passing through the
Multicutter in the direction indicated by the arrow at the
inlet.
Flow direction
If the Multicutter is suspended in a pipe system it
must be secured with a wire or similar attaching
the Multicutter to the building in order to prevent
the Multicutter from loosening and falling down by
accident.
11