Whirlpool akr 758 ixl Manual De Uso página 15

INSTALLATION - ASSEMBLY INSTRUCTIONS
The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of
this manual.
1. Using a pencil, draw the center line on the wall up to the ceiling to facilitate installation operations.
2. Place the drilling template against the wall: the vertical center line printed on the drilling template must match the center line drawn on the wall, and the
bottom edge of the drilling template must match the bottom edge of the hood.
3. Drill the 2 upper holes (Ø 8 mm).
Note: the lower central holes are not necessary for this model (safety holes will be performed subsequently in step 14-16)
4. Remove the drilling template, insert the wall plugs and fix the hood support bracket with two 5 x 45 mm screws.
5. Fit the flue support bracket to the wall and against the ceiling, use the flue support bracket as drilling template
(the small slot on the support, if present, must match the line drawn on the wall);
- mark 2 holes with the pencil
- drill the holes (Ø 8 mm)
- insert 2 plugs
- fix the flue support bracket to the wall with two 5x45 mm screws.
6. Extractor version only - rear extraction: drill a hole on the rear wall for the passage of the flue pipe.
7. Extractor version only - ceiling extraction: drill a hole on the ceiling for the passage of the flue pipe.
8. Prepare the connection to the household electrical system.
9. Filter Version only: adjust the filter deflector to the flue width (with 2 screws 2.9x6.5mm).
Fix the deflector to the flue support bracket (with 2 screws Ø 2.9x6.5mm).
10. Remove the grease filter.
11. Apply the two lateral brackets, for the adjustment block, to the motor box ( with 4 screws 3.9x25mm); fix the two adjustment blocks to the brackets
(with 4 screws 4x8mm).
12. Hook the hood to the bracket.
13. Adjust the hood horizontally.
Adjust the distance between the hood and the wall.
14. Mark the hole/s for final fixing of the hood as indicated.
15. Remove the hood from the wall.
16. Drill and insert the wall plugs as shown.
17. Rehook the hood to the wall.
18. Fix the hood to the wall with 2 screws 5x45mm and washers as shown. (COMPULSORY!!)
19. Remove the tape fixing the electronics box to the motor body.
20. Fully tighten the screws, already partially tightened, that fix the electronics box to the motor body.
Note: the box may be temporarily fixed to the top or sides of the motor body, the image is only for reference
21. Insert the power cable in the special seat.
22. Secure the cable to the cable clamp.
IMPORTANT: this operation is compulsory. It will prevent accidental disconnection of the power cable.
Carry out the connection to the household electrical system.
23. Extractor version only: install the fumes check valve (2 pieces) at the motor outlet.
24. Extractor version only: connect an exhaust pipe to the collar for the expulsion of fumes, the tube must be directed towards the outside; use the multi-
fitting flange in case it is necessary to reduce the outlet diameter to 120-125mm.
25. Filter version only: connect the fumes exhaust pipe to the filter deflector.
26. Fit the flues in place over the hood, completely covering the extractor unit.
27. Remove the upper section and fix the flues with 2 screws 2.9x6.5mm as indicated.
28. Filter version only: install the carbon filters at the motor sides.
29. Refit the grease filter.
GB13