Remote Control; Changing The Battery Of The Remote Control; Notes For Use; Connected Load - Profi Care PC-HL 3086 Manual De Instrucciones

Remote Control

NOTE:
The button cell in the battery compartment of the remote
control has been secured with a foil for transport. This
will extend the durability of the battery. Before initial use
please remove this foil so that the remote control is ready
for operation.
The range of the remote control is limited.
When using the remote control, please ensure that there
are no obstacles placed between it and the sensor on the
appliance.

Changing the Battery of the Remote Control

If the range of the remote control is reduced during use,
please proceed as follows:
1. Open the battery compartment on the bottom of the
remote control by holding the lever inwards and pulling
out the battery compartment.
2. Replace the button cell with a battery of the same type
(CR2025). Ensure correct polarity.
3. Then close the battery lid.

Notes for Use

Connected Load

The appliance supports a power input of 1500 W.
CAUTION: Overload
• When using an extension cord, it must have a cable
cross-section of at least 1.5 mm².
• Do not use multi-outlet power strips, since this appli-
ance is too powerful.
• Do not connect any other powerful appliances to the
same electric circuit.

Safety Switch

Your fan heater features a safety switch that disconnects
the power supply in case the appliance falls over. The safety
switch prevents hazards caused by overheating.
CAUTION:
Place the appliance on a smooth, horizontal surface. Avoid
carpets in order to prevent failure of the safety switch.
NOTE:
As soon as the safety switch has been activated, the
appliance must be set and switched on again.

Electric Connection

1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Connect the mains plug to a properly installed isolated
ground socket.
PC-HL3086_IM

Operating Buttons

The buttons on the appliance are sensor touch buttons. In
order to perform the corresponding function gently touch the
buttons. Whenever a button is pressed, it will be confirmed
by a beep sound.
Control Remote
Panel Control
UP
TEM.
Decrease temperature
DOWN
Time-delayed switch-off:
TIMER
TIMER
SWING Switch oscillation on / off
SWING
MODE
MODE
ON / OFF

Switching the appliance on / off

ON / OFF
NOTE:
In order to switch off the appliance using the button
MODE ON / OFF on the front, repeatedly press the button
until the Fan indicator lamp starts flashing. The display
shows and indicates the activated 30 second timer.

Operation

NOTE:
• The operation is explained using the buttons on the
remote control.
• The buttons can only be pressed once the appliance
has been switched on by using the
Switching the Appliance On / Off
• Use the on / off switch on the back to switch on the
appliance. To do this, set it to position I. You will hear a
signal tone.
• Start the appliance using the
The appliance activates the fan mode and starts op-
erating in setting 1. Both the indicator lamp above the
MODE ON / OFF button and the Fan indicator lamp start
to light up.
ON / OFF button again to switch off the
• Press the
appliance.
NOTE:
A 30 second timer will start in the display. During this
period the fan remains in operation to cool down the
appliance. The Fan indicator lamp is flashing. When
the timer period has lapsed, the appliance will auto-
matically switch into standby mode.
Function
Increase temperature
to hours
Power level selection
(Fan, Low and High)
ON / OFF button.
ON / OFF button.
43
18.06.20