4
Installation
4. Ensure that the cable notch on the dome camera base is aligned with the cable notch
on the wall mounting bracket. Align the 3 mounting holes on the dome camera base
with the 3 corresponding mounting holes on the wall mounting bracket.
1: Cable Notch
2: Mounting Holes
NOTE
The wall mount you received may have more or less mounting holes than the one depicted in this
guide. The mounting holes (3x) on the dome camera base will align with the corresponding mounting
holes on the wall mount.
5. Use the Hex Bolt M4x10 (x3) screws included with the wall mounting bracket kit to se-
cure the position of the dome camera base.
6. Holding the flat side of the back plate against the mounting surface, mark holes for the
mounting screws ST4 (x4) and the camera cable. Remove the back plate and drill
where marked.
NOTE
You do not need to mark holes for the camera cable if you plan to run it along the wall / ceiling.
1: Mounting screw ST4 (x4) holes, 2: Camera cable hole
#LX400075; r.41474/44665; en-US
10