RAVAK KASKADA EX RONDA Instrucciones De Montaje página 3

GB
ASSEMBLY INSTRUCTIONS - Shower Trays with Polyurethane
The Type EX is manufactured for direct assembly on a firm, level base. It is possible to install it either before tiling or after tiling in a
finished bathroom. The surface of this enables identical tiling of the tray and walls of the bathroom. We recommend completing the
shower tray with the Ravak siphon.
1.
Remove the top siphon cover using a flat, blunt object and
take out the sludge trap. Using the shoulders on the inside
diameter, unscrew the siphon.
2.
Place the shower tray in its final position and mark it on the
floor.
3.-3a
Make the outlet piping
connection to the siphon. It is possible to cut off parts of the
reinforcement to the maximal dimension 60X60 mm if
necessary, with a rotating cutter
4.
Adjust the siphon in the tray to it's correct position and
mark the position of the pipe joint. Finish the connection of
the outlet pipes and the siphon.
5.
Apply the silicone RAVAK PROFESSIONAL sealing
compound on the entire surface of the tray where it contacts
the floor. Apply the silicone compound on the tray approx.
10 mm from the outside bottom edge.
6.
Place the tray to in it's final position and screw the siphon
gently.
7.
Press the tray against the floor and remove excess sealing
compound.
8.
Finish the assembly of the siphon, fit on the top cover.
9.
The tiling can be a max. 5 mm over the outside edge of the
tray. The front part of the tray can be tiled at the same time as
the walls.
MAINTENANCE
When maintaining the shower bath, only wipe the painted parts, glass and plastic. Use a fine cloth and normal household
detergents. Never use any abrasive pastes, dissolvents, acetone or detergents and desinfectants, that contain chlorine.
manufacturer is not responsible for damage caused by inappropriate use, installation or maintenance of the product. The
manufacturer is entitled to continuous innovation of the product. For all other information concerning the installation, use and
maintenance ask your salesperson.
The manufacturer recommends: RAVAK CLEANER - works to remove old and dried-on debris from glass surfaces, shower
frames, enamel and acrylic bathtubs, washbasins and water taps; RAVAK DISINFECTANT - is a special preparation with
considerable anti-bacterial and anti-fungal effects.
Æ
40 mm and prepare the
Æ
40-50 mm.
Reinforcement
10.
The RAVAK Company produces a special assembly pack
for these installationsThis pack consists of two plastic strips, a
sealing foam strip and silicone sealing RAVAK
PROFESSIONAL compound. All these components are
determined for reliable sealing and the perfect apperance of
the connection. It is possible to tile the front surface of the tray
with the same tile as on the walls in the bathroom. If using an
another cement there is the risk the tray winn not be water
resistant.
Later deliveries have better packaging for protection of the
trays. This is why the contact foil is no longer included.
The