Manual Operation; Connecting The Appliance - S&P EMIDRY-D Manual De Instalación. Instrucciones De Uso

8. MANUAL OPERATION

8.1 Connecting the appliance

Set the ON/OFF switch located on the rear of the control panel to ON (with the
red part showing).Once the appliance is ON, the display shows the ambient
temperature. The blobs and pilots shown on the display may differ.
8.2 Function select
If the ON indicator on the display is not lit up, the appliance is in STOP. Press
the central key to set the mode
temperature in subdued light, and a blob lights up in the lower right corner of
the display to indicate the appliance is ON. If the temperature setting is higher
than the ambient temperature, the appliance will start heating up.
Press the key again and the heater enters mode
indicate this. The appliance will heat up if the temperature setting is at least
3.5ºC higher than the ambient temperature.
Press and hold the central
standby mode. The ON indicators disappears from the display (steady blob in
the lower right corner) and the appliance continues to display the ambient
temperature.
8.3 Temperature select
To set the desired temperature, press the
fully and with each successive press on the
setting increases or decreases by 1Cº. Once 5 seconds have elapsed with no
further keys pressed the display returns to subdued lighting mode and once
again shows the ambient temperature.
8.4 Anti-freeze function
Press the "minus" key until the lower threshold value is reached. The display
shows AF (anti-freeze) as shown below:
Where it
corresponds
When this function is activated, the appliance switches on when the ambient
temperature falls to 5ºC, keeping the temperature at between 5ºC and 6ºC.
. The display shows the ambient
button for 2 seconds to put the appliance in
or
17
. The blue pilot lights up to
keys. The display lights up
or keys the temperature
Always