Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOTE: Please make the ice maker be rested for 30
minutes before plug if it has been moved.
Open the top lid and remove the ice basket.
3.
WARNING: Fill the water reservoir with potable
4.
water only.
NOTE: Do not fill above the MAX water level mark.
Alternatively, you can operate the Ice Maker under
5.
the condition that it is supplied with water continuously by
following the operation as below:
Firstly
(1)
diameter:φ6.35mm) about 2m in length and then insert its
one end into the water inlet of Ice Maker.
Check and make sure that the three-way ball valve
(2)
equipped is compatible with the water tube and water
faucet in your home.
After checking, connect the three-way ball valve
(3)
with the tap water.
Connect the other end of the 1/4 water tube with the
(4)
1/4 tube connector of the three-way ball valve.
Check and make sure all the connection of water
(5)
tubes are tightly connected and then open the three-way
ball valve after confirmation.
Replace the ice basket and close the top lid.
6.
Press "
7.
small ice while " " means large ice.
Press the "
8.
solidly.
The ice-making cycle will last approximately 7-15
9.
minutes, depending on the ambient temperature and
water temperature
The ice-making cycle starts with water being pumped
10.
into the ice tray situated below the evaporator. Over the next
7-15 minutes ice forms on the evaporator. Once this has
completed, the ice tray will tilt backwards and the remaining
prepare
a
" key to select the ice size, "
" key and the "
1/4
water
"indicator lights
tube
(outer
" means
Tabla de contenido
