08
2. Particular Safety Instruction
1. Information of Noise Level.
(1) The noise level at the operator's position is about:
Sound Pressure Level : 89 ~ 94 dB(A).
Sound Power Level: 102 ~ 108 dB(A).
(2) Reference standard :ISO 3746.
2. Information of Vibration Level.
(1) The vibration level at the handle is about : 3.18 ~ 4.67 m/s2.
(2) Reference standard : EN 28662-1.
3. Information of Temperatures.
(1) The temperatures at the handle (8 hours/Operation) is 30º C.
4. How to operate.
(1)Turn on the air supply.
(2)Turn Tee-Handle adjusting screw clockwise on the tank regulator to increase material
pressure; turn it counterclockwise to decrease pressure.
Maximum tank pressure is 80 PSI.
(3)Atomization air for the spray gun can be adjusted at the gun by means of an air adjusting
valve or adding an air regulator kit to the tank. See accessories.
(4) Operate Spray Gun according to instructions accompanying gun.
5. Warnings.
(1) The power tools shall not be used in explosive atmospheres unless specially designed for
that purpose.
(2) Pay attention to the risk of a whipping compressed air hose.
6. Instructions.
(1) Equipped with a safety valve that continuously release excessive air when over
pressurization occurs (Max. 5 BAR/ 70 PSI).
(2) Use the air regulator valve to control and attain desired air pressure.
(3) To prevent continuous release of excessive air from the safety valve, use the air regulator
valve to shut-off air supply when spray gun is not in use.
(4) To prevent accidental injury, be sure to pull the ring of the safety valve and discharge all
inside the tank prior to opening and refilling paint.
7. Explanations of Warning Signs Used For This Tool:
The operator's Instruction must be read before work starts.
8. The weight of this tool is below : 1 Kgs. Note:
If the weight of this tool exceeds 15Kgs,the following attention shall be paid to:
(1)Be sure that you can afford the weight.
(2)Be sure to wear foot protection, to prevent the risk of impact due to the drop of tool.
ENGLISH