Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32

ENGLISH

INTRODUCTION
This manual will help you get the most from your Nilfisk-Advance SDH 5120.
Read it thoroughly before operating the machine.
Note: Bold numbers in parentheses indicate an item illustrated on page
3 (Figure C).
This product is intended for commercial use only.
PARTS AND SERVICE
Repairs, when required, should be performed by Nilfisk-Advance service
personnel using Nilfisk-Advance original replacement parts and accessories.
Call Nilfisk-Advance for repair parts or service. Please specify the Model and
Serial Number when discussing your machine.
NAME PLATE
The Model and Serial Number of your machine are shown on the Nameplate
on the machine. This information is needed when ordering repair parts for the
machine. Use the space below to note the Model and Serial Number of your
machine for future reference.
MODEL
SERIAL NUMBER
UNCRATING
When the machine is delivered, carefully inspect the shipping carton and the
machine for damage. If damage is evident, save the shipping carton so that
it can be inspected by the carrier that delivered it. Contact the carrier
immediately to file a freight damage claim.
24 - FORM NO. 56041370 / SDH 5120
PREPARING THE FLOOR
Before each use of this machine, the floor must be clean and completely dry.
Clean the floor with an automatic floor scrubber or a damp mop, using a
solution of water and neutral cleaner.
CAUTION!
This machine should be used only on floors that are coated with
a floor finish suitable for burnishing. Contact your local Nilfisk-
Advance Distributor for further information on floor finishing
products.
PREPARING THE MACHINE FOR USE
WARNING!
Moving parts - To reduce the risk of injury, unplug before
servicing.
A - INSTALLING THE PAD
To install a pad, tip the machine back on it's handle. Remove the Pad Retainer
"A" (in the center of the pad holder) by turning clockwise to loosen. Put the
proper size Pad "B" on the Pad Holder Hub "C". Re-install the Pad Retainer
"A" by turning counter-clockwise to tighten.
B - KNOW YOUR MACHINE
1
Operator Handle Grips
2
Switch Lever Safety Lock Button
3
Switch Levers - Squeeze - ON / Release - OFF
4
Handle Release Latch
5
Power Cord
6
Operator Handle
7
Motor Brush Wear Indicator Light
OPERATION
1
Unwrap the Power Cord (5) and plug it in to an outlet.
2
Unlatch the Operator Handle (6) by pushing forward on the Handle
Release Latch (4) with your foot. Continue to hold latch (4) while pulling
the handle (6) back. It is normal for the base of the machine to lift off
of the floor slightly when the handle is lowered. It will pull itself down
against the floor as soon as the motor is started.
3
Hold one of the Operator Hand Grips (1) firmly, push the Safety Lock
Button (2) and then compress the Switch Levers (3) to start the motor.
NOTE: The Safety Lock Button (2) will not depress unless the
Operator Handle (6) has been released and tilted back into the
operating position. When the dual controlled Switch Levers (3) are
released, the machine shuts off immediately.
4
Push the machine forward in a straight line, at a slow walking speed.
Overlap each pass about 1-3 inches (25-75 mm).
5
When using a polishing pad, check every 15 minutes to see if the pad
is loaded up with wax and dirt. If it is, turn the pad over to expose the
clean side, or install a clean pad.
Tabla de contenido
loading

Este manual también es adecuado para:

5620150456201800

Tabla de contenido