Tabla de contenido
Electric Overblanket Use instructions
The table (Fig. 2) indicates how many presses of the key correspond to a certain number
of leds and hence temperature level.
To prevent the blanket overheating, the Beper plaid is equipped with a safety sy-
stem which automatically returns it to its minimum setting after at most 1 hour of
operation.
10. The KDA6-FT control is also equipped with a timer (Time set key), which sets the
hours of operation of the blanket up to a maximum of 8 hours. To set the hours of opera-
tion, press button 3 repeatedly and check the number of hours by reading the leds as they
light up.
For example, pressing the time set key 3 times sets 3 hours of operation: 2 leds light up,
1 for the first hour and the second for the following two hours: in other words, the blanket
will operate for (1h+2h), a total of 3 hours.
The table (Fig. 3) shows the correspondence between the number of presses of the time
set key and the number of hours of operation.
TO CANCEL ALL THE TIMER AND TEMPERATURE SETTINGS, PRESS THE CANCEL
KEY.
Now you can make new settings as desired.
N.B.
IF THE LEDS ARE FLASHING, CHECK THAT THE CONTROL IS PROPERLY CON-
NECTED TO THE BLANKET.
PRESS THE CANCEL KEY TO STOP THE LEDS FLASHING, THEN MAKE THE SET-
TINGS AS DESIRED.
IF THE LEDS DO NOT STOP FLASHING, DISCONNECT THE BLANKET FROM THE
POWER SOCKET AND CHECK ITS POWER CORD FOR DAMAGE.
14
Tabla de contenido
