Tabla de contenido
TIPS FOR USE
Place the juicer on a flat and stable surface. Insert the plug in to a wall socket. As soon as the citrus fruit
is pressed onto the juice cone, the motor will be activated. The motor automatically changes directions
when it is switched on and off. The change of direction increases the juice collected.
After all the fruits have been squeezed or if the reservoir is full, the reservoir can be removed from the
base motor by turning it anticlockwise.
Do not exert too much pressure on the juice cone. If the sound of the motor increases significantly or the
motor itself slows down dramatically, this means too much pressure has been exerted.
CLEANING
ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING.
Clean the juicer after each use to prevent leftover food from sticking. The reservoir can be removed from
the base motor by turning it anticlockwise. Each component can be washed in hot soapy water, with the
exception of the motor base. Do not use abrasive or strong detergents. Wipe the motor base with a damp cloth.
NEVER IMMERSE THE MOTOR BASE IN WATER OR OTHER LIQUID.
PRINCESS TIPS
- Do not run the juicer for more than 5 minutes at one time.
- This juicer is only suitable for household use.
- Make sure the cord or extension cord is carefully positioned to avoid people tripping over it.
- If the juicer or cord is damaged, we advise you not to use the appliance and to take it to the retailer for
repair. Damaged cords must be replaced by our service department.
- Do not use this juicer outdoors.
- Ensure children do not use the juicer unsupervised.
- Children should be supervised to ensure that they do not play with the appliance.
- The use of this appliance by children or persons with a physical, sensory, mental or motorial disability,
or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety
should give explicit instructions or supervise the use of the appliance.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE
NEUTRAL
BROWN
LIVE
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.
If a 13Amp (BS1363) plug is used, a 3 (BS1362) fuse must be fitted, or if any other type of plug is used,
a 15Amp fuse must be fitted, either in the plug or adaptor, or on the Distribution Board.
THIS IS A DOUBLE INSULATED APPLIANCE AND DOES NOT NEED AN EARTH CONNECTION
WARNING: ON NO ACCOUNT SHOULD EITHER THE LIVE OR NEUTRAL WIRES BE
CONNECTED TO THE EARTH TERMINAL.
5
Tabla de contenido
